Wet, cold, dirty – that’s the state of the streets this time of year. It means deep soiling to office and leisure area carpets that’s more difficult to remove come the next scheduled extraction clean. If only there was a way of keeping them looking good a few weeks after a big clean and help reduce time and effort spent on the next one?
Without getting too scientific, the encapsulating spray basically carries out two functions. Its soil release agents detach all types of soil and other old residues from the carpet or fabric fibres by binding with them.
Then, as the polymer-based solution dries, it hardens to a brittle, crystalline structure, encapsulating or trapping soil and residues in the dried particle. These hard crystals (not visible to the naked eye) can then be easily removed when the carpet is next vacuumed.
Being a low moisture method, encapsulation system drying times are considerably reduced with carpet dry in as little as 20 minutes and application times reduced.
Next – what to use.
I recommend Fibreclean for large areas with its new formulation and fresh “ocean breeze” fragrance. Just spray the diluted solution lightly over the carpet with a low pressure sprayer and then brush in with a pile brush or with the aid of a cylindrical brush machine.
Fibreclean can also be used on hard-wearing upholstery, making it a particularly useful method of cleaning in transport environments such as trains and buses where quick drying is favoured.
WoolSafe-approved and specially designed to help prevent re-soiling, Procaps incorporates a high quality encapsulation cleaning formula with a new lemon and lime fragrance.
Of course, interim encapsulating maintenance solutions like these don’t actually replace a deep extraction clean. But carry them out at suitable intervals between cleans and they will help to maintain a carpet’s appearance, performance and extend its working life.
They are also quick and less disruptive to use, opening up more opportunity to get on site and apply them.
The Prochem how-to-use guide….
Always dry vacuum before applying the spray solution.
Use the correct dilution rate and do not over-apply. This is primarily a low moisture, quick drying method: one litre of diluted solution should cover approximately 25 square metres of carpet, depending on the depth of the pile.
Use a pressure sprayer with a fan spray nozzle; after a two to five minute dwell time the solution should be thoroughly brushed in and right down the pile ideally using a machine designed for the task such as the Fiberdri TM4 or PRO 35 or if not available use a carpet pile brush. On upholstery, lightly spray with a pump-up hand sprayer and brush with an upholstery brush.
Fibreclean and Procaps should not be mixed with any other chemicals as these could interfere with the soil encapsulating crystals. Procaps can be used at a stronger dilution rate (1 to 4 or even full strength) as a spotter on difficult stains prior to spray cleaning.
To download our free Guide to Carpet Care click the lin below:
You can call us 020 7700 3322 or email firstname.lastname@example.org
For additional information and updates from ths blog please leave your details below